• Service and Maintenance Manual Model 40H+6 3120240 October 11, 2001 ANSI. • • USE ONLY APPROVED, NONFLAMMABLE CLEANING SOLVENTS. Relieve system pressure by cycling the applicable control several times with the engine stopped and ignition on, to direct any line pressure back into the reservoir. Pressure 3120240 – JLG Lift –. • EFFECTIVITY CHANGES REVISON LOG Aug, 1985 -Original Issue Nov. 1985 -Revised Oct. 1998 -Revised Aug.

1999 -Revised October 11, 2001 -Revised – JLG Lift – 3120240. • Drive Brake, Mico. (Machines Built From May 1992 To S/n 33476) (See Figure 2-44.).2-79 2.31 Swing Brake, Mico. (Machines Built From May 1992 To S/n 33476) (See Figure 2-45.).2- – JLG Lift –. • Vickers All Hydraulic Machines Pressure Settings (Sheet 1 of 4).2-51 – JLG Lift – 3120240.

Your One Stop Shop for JLG Parts - TMSEquip.com. JLG Part # 3120096 - MANUAL 40F ILLUSTRATED PARTS, EA. JLG Parts, Operation and Service Manual link. JLG Part # 3120096 - MANUAL 40F ILLUSTRATED PARTS, EA. JLG Part # 3120096 - MANUAL 40F ILLUSTRATED PARTS, EA. JLG Parts, Operation and Service Manual link.

• Platform Assembly Troubleshooting..3-2 3120240 – JLG Lift –. • Electrical Assembly Troubleshooting..3-16 (INTENTIONAL BLANK PAGE) – JLG Lift – 3120240.

• (5.5 L) w/0 Filter. Battery - 1000 cold cranking Amps, 210 min- Low RPM 2000. Utes reserve capacity,12 VDC. High RPM 3000. Fuel Consumption Low RPM - 2.03 GPH (7.68 LPH).

Alternator - 60 Amp, belt drive. 3120240 – JLG Lift –. • 10 Microns Nominal. Steer System. Hydraulic Filter - On-line (Racine Valve Only). Tires - 12.5 x 15, 12 ply rating, 72 PSI.

Toe-in, adjust for 1/4 in. (6.35 mm) overall. Return - Non-Bypass Type.

– JLG Lift – 3120240. • SECTION 1 - SPECIFICATIONS 10 Microns Nominal. Yamaha V Star 1100 Custom Manual. Machine Stowed Height. Model 40H (2WD) - 7 ft., 10 in. PERFORMANCE DATA. Model 40H (4WD) - 7 ft., 10 in.

Machine Stowed Length. Travel Speed. Model 40H (2WD) - 25 ft.,2 in. • -15° F - +70° F. 10W-30 any remaining diesel fuel. Aside from JLG recommendations, it is not advisable (-26°C. To +21°C.) to mix oils of different brands or types, as they may -15° F - +85° F.

• SECTION 1 - SPECIFICATIONS Figure 1-1. Torque Chart. 3120240 – JLG Lift –.

• SECTION 1 - SPECIFICATIONS Figure 1-2. Lubrication Chart. (Sheet 1 of 2) – JLG Lift – 3120240. • NOTE: Lubrication intervals are based on machine operations under normal conditions. For machines used in multi shift opera- tions and /or exposed to hostile environments or conditions, lubrication frequencies must be increased accordingly. Lubrication Chart.

(Sheet 2 of 2) 3120240 – JLG Lift –. • Lift Down - 1200 psi. Swing - 1100 psi. Main Relief - 3200 psi. (220.64 Bar).

Sequence Cartridge - 450 psi. Pressure Reducing - 600 psi. – JLG Lift – 3120240. • (4WD) Telescope 3.00 174.18 2.00 (2 Section Boom) Telescope 3.00 110.31 2.00 (3 Section Boom) Steer (2WD) 3.00 8.06 1.25 Steer (4WD) 3.00 9.81 1.50 Extend-A-Reach Lift 3.00 12.687 2.00 Slave 3.50 7.25 1.

– JLG Lift –. • In addition, the last five digits of the serial number are stamped on top of the fly and base end of the boom and on the left side of the turntable. – JLG Lift – 3120240 1-10.

• SECTION 1 - SPECIFICATIONS Figure 1-3. Serial Number Locations. 3120240 – JLG Lift – 1-11. • SECTION 1 - SPECIFICATIONS intentional blank page – JLG Lift – 3120240 1-12. If bearing is found to be serviceable, apply a light order to function properly.

Coat of oil and wrap it in clean (waxed) paper. Do not 3120240 – JLG Lift –. • NOTE: Metal particles may appear in the oil or filters of new the specified intervals. When recommended lubricants are machines due to the wear-in of meshing compo- not available, consult your local supplier for an equivalent that meets or exceeds the specifications listed. – JLG Lift – 3120240.

• Lubrication Chart. Refer to Table 1-1 for recommendations for viscosity ranges. CYLINDERS - THEORY OF OPERATION. Ryobi Rht2660da Petrol Hedge Trimmer Manual. JLG recommends Mobilfluid 424 hydraulic oil, which has an SAE viscosity of 10W-30 and a viscosity index of 152. Systems Incorporating Double Acting.

• The load drop check prevents any drop of a suspended JLG Industries, Inc. Requires a complete boom disassem- load before upward movement. Bly, per instructions outlined in the 2-11 boom disassem- b ly, ever y tw o year s. DAMAGE AND/OR BREAKAGE OF THESE ITEMS COULD THE BOOM ASSEMBLY AND COULD CAUSE SERIOUS INJURY OR RESULT IN UNCONTROLLED EXTENSION OR RETRACTION OF DEATH TO PERSONNEL OPERATING THE JLG BOOM LIFT. Typical Three Section Boom Assembly. Inspection Procedures.